English - Español - Français - Deutsch - Italiano
ACTIVATING ELECTRICAL COMPONENTS W/GROUND (PPM)Contact the probe tip to the negative terminal of the component, the LED indicator should light RED. Wh
10CHECKING FOR BAD GROUND CONTACTS (PPM)FOLLOWING & LOCATING SHORT CIRCUITS (PPM)Probe the suspected ground wire or contact with the probe tip.Obs
/11MODESThe Power Probe III has been designed to work the same as the previous Power Probe circuit testers. Using the ad-vanced features and modes is
12Mode #4 Peak to Peak Mode: The Peak to Peak Mode measures the difference between the positive and negative peak voltage levels over a 1 second perio
13Power Probe 3 Specifi cationsDC 0 – 70V + 1 digitP-P 0 – 70VFrequency response of tone pass through10Hz to greater than 10 KhzPP display15Hz Squar
ROCKER SWITCH REPLACEMENTEnglish
INTRODUCTIONThank you for purchasing the NEW Power Probe III (PP3). The PP3 is our most revolution-ary circuit tester to date. The PP3 literally speed
Table of ContentsHook-up and quick self-test ...
HOOK-UP/3ModeButtonPower SwitchUnroll the Power Probe cable. Connect the RED battery hook-up clip to the POSITIVE terminal of the vehicle’s battery.
412.00.0While the PP3 is in Power Probe Mode. Contact the probe tip to a NEGATIVE circuit. The green negative sign “-” LED will light. If the audio f
0.0CONTINUITY TESTING (PPM)While the PP3 is in Power Probe Mode, and by using the Power Probe tip in connection with chassis ground or the auxiliary g
ACTIVATING COMPONENTS IN YOUR HAND (PPM)While the PP3 is in Power Probe Mode and by using the Power Probe tip in connection with the aux-iliary ground
TESTING TRAILER LIGHTS AND CONNECTIONS (PPM)1. Connect the PP3 to a good battery.2. Clip the auxiliary ground clip to the trailer ground.3. Probe the
ACTIVATING COMPONENTS IN THE VEHICLE (PPM)To activate components with positive (+) voltage: Contact the probe tip to the positive terminal of the comp
Comments to this Manuals